Lenze PROFIBUS Controller-based Automation Uživatelský manuál stáhnout pdf (Strana 46)

9 Defining the minimum cycle time of the PLC project

9.2 Optimising the system

Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.3 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

9.2 Optimising the system

 How to optimise the system:

1. Use the menu command Online  Login, or log in on the Lenze Controller with <Alt>+<F8>.

• For this, the PLC program must be error-free.

• With the log-in, the fieldbus configuration and the PLC program are loaded into the

Controller.

2. Check the task processing times.

3. Optimising the cycle times:

• If technologically required, the cycle times of the remaining tasks with lower priorities

can be decreased.

• Condition: No task with a low priority must assign more than 60 percent of the

corresponding cycle time in its task utilisation.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 54 55

Žádné komentáře

Lenze PROFIBUS Controller-based Automation Uživatelský manuál Strana 46