Lenze CANopen Controller-based Automation Uživatelský manuál stáhnout pdf (Strana 86)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 86

9 Commissioning of the CANopen Motion bus

9.10 Setting SoftMotion parameters

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2. Open the tab SoftMotion drive: basic parameters and set the axis types and limitations.

• Do not use the "virtual mode" setting.

• Virtual axes are in the "SoftMotion General Drive Pool".

Configuration of a Motion device Rotary axis

(type: Modulo, 360°/revolution, ratio 1:1):

For configuring a linear axis Motion device (type: Finite), you can activate and determine

the software limit switches:

3. Repeat steps 1 and 2 for all Motion devices participating on the fieldbus.

 Online help of »PLC Designer«

Here, you can find detailed descriptions of the SoftMotion tabs.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 109 110

Žádné komentáře

Lenze CANopen Controller-based Automation Uživatelský manuál Strana 86