Lenze c300 Uživatelský manuál stáhnout pdf (Strana 34)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17 34

5 Commissioning the controller

5.4 Configuring the controller

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

5.4.2.1 Cabinet controllers with external monitor panels (3231 C/3241 C)

 Tip!

Connect a keyboard to the Controller to be able to enter the IP address.

Then you can make the entries:

[5-1] IP settings of the controller by default

• Start the control panel with <Shift+F4>.

• Start the network connections by double-click and enter the IP address, subnet mask, and the

default gateway.

• After clicking the button the IP address is saved and need not be entered again when the

system is restarted.

 Note!

If an external display (monitor panel) is used, the switch-on sequence of display/

controller must be observed so that it can be correctly controlled by the controller:

• Connect the external display to the DVI output of the controller and switch it on

before

switching on the controller.

After connection of a monitor panel/an external display to a running controller, the

display resolution is VGA .

• Calibrate the monitor panel/ display connected, so that the screen content can be

displayed correctly.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 194 195

Žádné komentáře

Lenze c300 Uživatelský manuál Strana 34