Lenze PROFINET Controller-based Automation Uživatelský manuál stáhnout pdf (Strana 20)

6 Commissioning of the PROFINET

6.1 Overview of the commissioning steps

Lenze · Controller-based Automation · PROFINET® Communication Manual · DMS 1.2 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

6 Commissioning of the PROFINET

This chapter provides information on how to commission the Lenze automation system with

PROFINET.

Depending on the field devices used, the following Lenze Engineering tools

( 17) are required:

• »EASY Starter«

• »Engineer«

•»PLC Designer«

6.1 Overview of the commissioning steps

The main commissioning steps are listed in the following table.

 Note!

• In the Lenze automation system, no PROFINET master functionality is supported. In a

PROFINET network, a Lenze Controller can only be driven as I/O device (slave), e.g. by

a Siemens SIMATIC S7 PLC.

• In the Lenze automation system, Logic field devices can be exclusively operated via

PROFINET. Thus, as an I/O device, the Lenze Controller is a Logic field device.

• The motion functionality is not supported when PROFINET is used. Always use

EtherCAT to connect inverters to be controlled via the central Motion functionality.

Mixed operation PROFINET with EtherCAT

( 32)

Step Activity Software to be used

1st Planning the bus topology

( 21)

2nd Installing field devices

( 21)

3rd Create a project folder ( 22)

4th Commissioning the field devices

( 22) »Engineer«/»EASY Starter«

If necessary Importing missing devices / device description files

( 23)

»STEP7«

5th Creating a PLC program with a target system (Logic)

( 24) »PLC Designer«

6. Configuring the communication parameters ( 26)

7. Creating a control configuration (adding field devices)

( 28)

8. Configuring the I/O device

( 31)

9. Logging in on the controller with the »PLC Designer«

( 31)

With the log-in, the I/O device configuration is loaded into the

controller.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Lenze PROFINET Controller-based Automation Uživatelský manuál Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Lenze PROFINET Controller-based Automation