Lenze PROFINET Controller-based Automation Uživatelský manuál stáhnout pdf (Strana 9)

Lenze · Controller-based Automation · PROFINET® Communication Manual · DMS 1.2 EN · 04/2014 · TD17 9

3 Controller-based Automation: Central motion control

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3 Controller-based Automation: Central motion control

The Lenze automation system "Controller-based Automation" serves to create complex automation

solutions with central motion control. Here, the Controller is the control centre of the system.

System structure of the Controller-based Automation: "All from one single source"

[3-1] Example: PROFINET with a Siemens SIMATIC S7 PLC (Lenze Controller 3221 C with I/O system 1000 and Servo Drive 9400 as

I/O devices)

 Note!

In the Lenze automation system, no PROFINET master functionality is supported. In a

PROFINET network, a Lenze Controller can only be driven as I/O device (slave), e.g. by a

Siemens SIMATIC S7 PLC.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Žádné komentáře

Lenze PROFINET Controller-based Automation Uživatelský manuál Strana 9