Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Uživatelský manuál stáhnout pdf (Strana 23)

Lenze · PLC Designer | Migration of V2.x projects · 1.2 EN - 02/2013 23

Update of a project from V2.x to V3.x

Import of the example project into the »PLC Designer« V3.x

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

5. Recreate control configuration.

This means the following for this example:

• Insert dummy axes as virtual axes below the available node L-force Motion General Drive Pool.

• Insert CAN bus, adapt baud rate

• Insert CANopen manager

•Insert devices

• Adapt device settings (e.g. names, node number, basic configuration, mapping, PDO features).

 Note!

Libraries

Device-internal and fieldbus-internal libraries are automatically available after the

import of the »PLC Designer« V2 project. No manual update of the libraries required!

Control configuration

When a V2 project is imported into V3, the control configuration gets lost. Thus, it has to

be recreated in the »PLC Designer« V3.

Logic and Motion devices

• When the system is installed, we recommend to connect the Logic and Motion devices

to separate phases!

• Separate bus phases for Logic and Motion devices are not

mandatory in the »PLC

Designer« V3 (in contrast to the »PLC Designer« V2.3) .

 More information on the bus-specific configuration can be found in the following

documentation:

• Controller-based Automation EtherCAT communication manual

• Controller-based Automation CANopen communication manual

• Controller-based Automation PROFIBUS communication manual

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Žádné komentáře

Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Uživatelský manuál Strana 23