Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Uživatelský manuál stáhnout pdf (Strana 8)

Safety instructions

8 Lenze · PLC Designer | Migration of V2.x projects · 1.2 EN - 02/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3 Safety instructions

Please observe the following safety instructions when you want to commission a controller or sys-

tem using the L-force Controller.

 Read the documentation supplied with the corresponding field device thoroughly before

starting to commission the devices with the L-force Controller!

The device documentation contains safety instructions which must be observed!

 Danger!

According to our present level of knowledge it is not possible to ensure the absolute free-

dom from errors of a software.

If necessary, systems with built-in controllers must be provided with additional monito-

ring and protective equipment according to relevant safety regulations (e.g. law on tech-

nical equipment, regulations for the prevention of accidents), so that an impermissible

operating status does not endanger persons or facilities.

During commissioning persons must keep a safe distance from the motor or the machi-

ne parts driven by the motor. Otherwise there would be a risk of injury by the moving

machine parts.

 Stop!

If you change parameters in the »Engineer« or the »WebConfig« while a device is con-

nected online, the changes will be directly accepted by the device!

A wrong parameter setting can cause unpredictable motor movements. By unintentio-

nal direction of rotation, too high speed or jerky operation, the driven machine parts may

be damaged!

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Žádné komentáře

Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Uživatelský manuál Strana 8