Lenze DSD Uživatelský manuál stáhnout pdf (Strana 275)

100

101

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23 275

8 Motion design

8.3 Predefined motion profile according to operating mode

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8.3.5.8 Operating time

8.3.5.9 Brake at standstill

8.3.5.10 Controller inhibit at standstill

8.3.5.11 Acceleration time

8.3.5.12 Deceleration time

8.3.5.13 Cycle time

Parameter Description

The operating time corresponds to the load time of the drive.

• The designation of the operating mode is supplemented by the operating time, e. g. "S2-

60 min".

Parameter Description

Active • Yes

• The brake is active at standstill. If the brake is activated, the motor does not have to provide

a torque.

•No

• The brake is not active at standstill.

Parameter Description

Active • Yes

• The controller inhibit of the inverter is set. The thermal load of the inverter and motor is

reduced by this.

•No

• The controller inhibit of the inverter is not set.

Parameter Description

acc

Acceleration time required by the drive until the constant load condition is reached.

Parameter Description

dec

Deceleration time required by the drive until standstill.

Parameter Description

t The cycle time corresponds to the duration of the load phase.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 495 496

Komentáře k této Příručce

Žádné komentáře

Lenze DSD Uživatelský manuál Strana 275

Komentáře k této Příručce

Související produkty a manuály pro Software Lenze DSD