Lenze ETC Motion Control Uživatelský manuál stáhnout pdf (Strana 75)

100

101

Getting started

PLC keys in the ETC−MMI

Labelling of the PLC keys in the ETC−MMI

2.14

2.14.1

EDSTCXN EN 2.0

2.14 PLC keys in the ETC−MMI

In the "PLC KEYS" operating mode, it is possible to start manual functions in

the PLC from the ETC−MMI. For this purpose, 6 menu levels are available. This

corresponds to 42 function keys.

In this example, the following assignments are to be made to three PLC keys:

F1: System on/off

F4: Lower tool

F5: Lift tool

2.14.1 Labelling of the PLC keys in the ETC−MMI

The labelling of the PLC KEYS is realised in the language−dependent file

lenze.txt.

ETCN037

These texts are then assigned to the keys by the configuration file

delphmmi.ini :

ETCN038

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 427 428

Komentáře k této Příručce

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Uživatelský manuál Strana 75

Komentáře k této Příručce

Související produkty a manuály pro Software Lenze ETC Motion Control