Lenze PLC Designer PLC Designer (R2-x) Uživatelský manuál stáhnout pdf (Strana 321)

100

101

L-force | PLC Designer

Editors in PLC Designer

 DMS 3.2 EN 02/2011 TD29 319

'Extras' 'Step Attributes'

With this command you can open a dialog box in which you can edit the attributes for

the marked step.

Dialog Box for Editing Step Attributes

You can take advantage of three different entries in the step attribute dialog box.

Under Minimum Time, you enter the minimum length of time that the processing of

this step should take. Under the Maximum Time, you enter the maximum length of

time that the processing of this step should take. Note that the entries are of the TIME

type, so you use a TIME constant (i.e. T#3s) or a variable of the TIME type.

The time settings are also accessible in dialog 'Extras' 'Time Overview'.

Under Comment you can insert a comment to the step. In the 'Sequential function

chart options' dialog which you open under 'Extras' 'Options', you can then define

whether comments, the time setting or nothing is displayed for the steps in the SFC

editor. On the right, next to the step, either the comment or the time setting or none

of both will appear.

Those attributes which are not displayed because of the options settings, can -

additionally to the step name - be displayed in a tooltip, which appears when the

cursor is placed on the upper resp. lower right corner of the step box.

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 843 844

Komentáře k této Příručce

Žádné komentáře

Lenze PLC Designer PLC Designer (R2-x) Uživatelský manuál Strana 321

Komentáře k této Příručce

Související produkty a manuály pro Software Lenze PLC Designer PLC Designer (R2-x)