Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Uživatelský manuál stáhnout pdf (Strana 14)

Requirements

Establishing communication with the controller

Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

•Enter the desired IP address of the controller.

[3-1] Example: Enter the IP address of the controller.

3. Click OK to add the controller as gateway.

4. By double-clicking the desired channel (or clicking the Set active path button), set the

channel selected in the device view below the gateway as active path to the controller.

• Thus, all communication actions directly refer to this channel.

• The currently active path is represented in bold in the list and "(active)" is attached:

5. A device represented in italics is set as active path but has not been found during the last

network scan.

 Note!

• During initial commissioning, observe the following predefined IP addresses of the

controllers:: 192.168.5.99

 Further information can be found in the following documentation:

• Controller - Parameter setting & configuration

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 176 177

Žádné komentáře

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Uživatelský manuál Strana 14