Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Uživatelský manuál stáhnout pdf (Strana 48)

Working with the ApplicationTemplate

Mapping the actual machine structure in the »PLC Designer«

Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Setting of CAN parameters and PDO mapping

Set the CAN parameters and the PDO mapping for each Logic device connected to the bus.

 How to set CAN parameters and CAN mapping:

1. Change to the CANopen Remote Device tab of the corresponding slave.

Assign the suitable node addresses of the devices in the Node ID input field:

Only if the Expert settings option is set, the following settings are possible and visible:

• "Node Guarding"

•"Emergency"

•"Heartbeat"

• "Checks at Startup"

Make the settings required for your application here.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 176 177

Žádné komentáře

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Uživatelský manuál Strana 48