Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál stáhnout pdf (Strana 40)

L-force | PLC Designer

Lenze Specific Functions

38 DMS 4.1 EN 03/2011 TD29 

Inputs (VAR_IN)

Designator / Data type Info / Setting options

xExecute When a new positive edge is set, a new measurement is started. All

outputs of the block are reset to the initial values.

xWindowsOnly Activation of window evaluation: All measured values outside the

defined window are suppressed.

wExternalDelayCompensation Manual compensation for the propagation times of the axis positions

on the respective fieldbus. The delay time is entered in [µs].

lrFirstWindowPosition Lower limit of the window in SoftMotion units [SM units]

lrLastWindowPosition Upper limit of window in SoftMotion units [SM units]

TriggerInput See below description: L_SMC_Trigger_REF

TriggerInput / L_SMC_Trigger_REF:

Variable Type Initial

value

Description

TouchProbeSelect BYTE 1 Selection of TP1 or TP2

1: TP_Channel1 -> DigIn 1

2: TP_Channel2 -> DigIn 2

TouchProbeMode BYTE 1 Selection of operating mode

1: Single measurement; Execute edge activates

the function until Done = 1 (TRUE) or abort by

means of FB L_SMC_AbortTrigger.

2: Continuous measurement; Positive execute

edge activates the function until negative

execute edge (Execute = FALSE) or abort by

means of FB L_SMC_AbortTrigger.

TouchProbeSignal BYTE 1 Selection of zero pulse or digital input

1: Digital input

TouchProbeEdge BYTE 1 Configuration of edge evaluation

1: Triggering with positive edge

2: Triggering with negative edge

3: Triggering with positive or negative edge

(logic in the FB)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 116 117

Žádné komentáře

Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál Strana 40