Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál stáhnout pdf (Strana 42)

L-force | PLC Designer

Lenze Specific Functions

40 DMS 4.1 EN 03/2011 TD29 

Error messages

The following error messages have been stored:

Error message Description

411 TouchProbeSelect incorrect: TP channel does not exist

TouchProbeSelect > 1 in the case of ECSxM

TouchProbeSelect > 2 in the case of 9400

412 TouchProbeMode incorrect: Only the values 1 or 2 are permitted.

413 TouchProbeEdge incorrect: Only the values 1, 2 or 3 are permitted.

414 TouchProbeEdge incorrect: Requested edge evaluation does not exist

TouchProbeEdge > 2 in the case of ECSxM (Only positive or negative edge

possible.)

TouchProbeEdge > 4 in the case of 9400 (Type of edge evaluated not

supported.)

415 TP channel not free:

TP channel has already been activated by means of other block.

416 Touch probe is not possible for the currently selected process data

mapping.

417 Internal error / TP channel not free:

TP channel has already been activated by means of other block.

418 Internal error:

Timeout during assignment of the drive

419 Internal error: Communication error

421 TouchProbeSignal incorrect: Only the value 1 is permitted.

430 The FreeEncoder axis specified at the Axis input does not exist

431 The FreeEncoder axis specified at the Axis input is configured incorrectly

432 TouchProbeEdge selection incorrect

433 TouchProbeEdge selection incorrect

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 116 117

Žádné komentáře

Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál Strana 42