Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál stáhnout pdf (Strana 41)

L-force | PLC Designer

Lenze Specific Functions

 DMS 4.1 EN 03/2011 TD29 39

Outputs (VAR_OUT)

Designator / Data type Value / Meaning

xDone This output is set to TRUE when the parameter has been written

correctly.

xBusy This output is set to TRUE as long as the writing has not been completed.

xError This output is set to TRUE if an error occurs during writing. eError

outputs the cause of the error.

ErrorID Error number

xValueStored_PosEdge Measured value saved after triggering on positive edge

lrRecordedPosition_PosEdge Measured value in the case of triggering with the positive edge in

SoftMotion units [SM units], i.e. the measured value is supplied to the

PLC application in the same unit in which the axis is programmed.

xValueStored_NewEdge Measured value saved after triggering on negative edge.

lrRecordedPosition_NegEdge Measured value in the case of triggering with the negative edge in

SoftMotion units [SM units], i.e. the measured value is supplied to the

PLC application in the same unit in which the axis is programmed.

xActivationLevel Level of the TP input at the time of TP function activation in the drive.

The application can detect the nature of the first active edge by

evaluating the activation level when a "positive or negative edge" is

assigned.

xCommandAborted Block aborted by means of L_SMCAbortTrigger. The outputs "Busy" and

"Done" are reset.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 116 117

Žádné komentáře

Lenze PLC Designer PLC Designer (R3-1) Uživatelský manuál Strana 41