Lenze PLC Designer R3-x Uživatelský manuál stáhnout pdf (Strana 33)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014 33

Working with the sample projects

Sample project with the "Actuator speed" application - Actuator Speed

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.1.6 Operation via the visualisations in the »PLC Designer«

7.1.6.1 Information/start page

[7-3] Visualisation start page of the sample project Lenze 8400 HighLine - Actuator Speed

• Via the buttons in area , the mode (automatic, manual, service) can be selected.

•In area , SDO services (read/write parameters) for the controller can be selected.

• The button in area  refers to the start page which displays the version identifier of the project

and the libraries in area .

• Dialog box shows the status of the machine.

• Control field  shows the bus communication status.

• Control field Error indicates the error message status.

• Error in the application

• Error in the controller

•The Error Reset button resets the error messages.

 Select mode  Information/start page Status

Parameter

selection

 Version identifier  Status

 Note!

If a bus communication error occurs, the control and drive controller are to be restarted,

since the sample application does not support an automatic reset of bus

communication.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 158 159

Žádné komentáře

Lenze PLC Designer R3-x Uživatelský manuál Strana 33