Lenze PLC Designer R3-x Uživatelský manuál Strana 57

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 159
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 56
Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014 57
Extending sample projects - adding devices
Create control configuration - bus system CAN
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5. Use the command Add Device to add a Logic device (slave) to the CANopen_Manager
(master).
Select the desired CAN node from the selection list.
Tip!
For the implementation of other controllers, a general device description is provided: Lenze
Generic Drive.
Further information on the function block of the general device control can be found in the
following section: L_LCB_GenericDrive
( 130)
Repeat the Add Device command until all slaves connected to the bus are
implemented in the control configuration. Optionally, you can Copy and Paste a node
already inserted into the context menu of the device. The communication settings (node ID
and baud rate as well as further parameters) must be adapted manually.
Zobrazit stránku 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 158 159

Komentáře k této Příručce

Žádné komentáře