Lenze EtherCAT Controller-based Automation Uživatelský manuál stáhnout pdf (Strana 46)

7 Commissioning of the system

7.3 Detailed description of the commissioning steps

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

[7-1] Parameter set transfer from »PLC Designer« to the Servo-Inverter i700 via the 3231 C controller

The parameters of the Servo-Inverter i700 are managed within the »PLC Designer« project. With the

help of the storage function of »PLC Designer«, the »PLC Designer« project, including the i700

parameters, are stored on the Engineering PC.

During login to the Lenze Controller,»PLC Designer« transfers the i700 parameters to the controller.

The latter, in turn, transfers the parameter sets to the lower-level Servo-Inverter i700.

Whenever the system is booted, the parameter sets are written into the Servo-Inverter i700 again

by the Lenze Controller.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 204 205

Žádné komentáře

Lenze EtherCAT Controller-based Automation Uživatelský manuál Strana 46