Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) Uživatelský manuál stáhnout pdf (Strana 94)

2.12 MCTRL_MotorControl (node number 131)

9300 Servo PLC

System blocks

2−80

9300 Servo PLC EN 5.0

2.12.17.16 Sd8 − sin/cos encoder monitoring during operation

This monitoring function performs a plausibility check to find out whether the encoder is available and

the sin/cos tracks supply plausible values with regard to each other.

Error

Monitoring function System variable

Possible responses

No. Display TRIP Message Warning FAIL−QSP Off

x088 Sd8 Absolute value encoder error MCTRL_bSinCosFault_b  

 Lenze setting

 Setting possible

 The following sin/cos encoder types are supported:

– Stegmann SCS 60/70 ST 512 single−turn absolute value encoder (512 inc/rev)

– Stegmann SCM 60/70 ST 512 multi−turn absolute value encoder (512 inc/rev)

 The error "Sd8" can only be reset by mains switching.

 It may be necessary that the encoder has to move a few angular degrees for triggering an

error.

 The response is set under C0580:

Code LCD

Possible settings

IMPORTANT

Lenze Selection

C0580 MONIT SD8

3 Monitoring configuration: Sin/cos

encoder

0 TRIP

3 Off

Note!

If the encoder is to be monitored and, especially, if synchronous machines are used, the error

response should be set to "TRIP".

For further encoder reliability, the monitoring of following errors can, for example, additionally be

activated for positioning systems. This error response should also be set to "TRIP".

Apparent errors Hidden errors

 Unplugged connectors, all encoder signals open.

 Single open circuit, one of the following signals is missing:

– COS A

– RefCOS A

– SIN B

– RefSIN B

– GND

– VCC

 Double open circuit with the following signal pairs:

– COS A and RefCOS A

– SIN B and RefSIN B

– COS A and SIN B

– RefCOS A and RefSIN B

– or all four signals (COS A, RefCOS A, SIN B, RefSIN B) open.

 Short circuits, especially between the sine and cosine signals.

 Cable/encoder interferences with intermediate values

 "Semi"−short circuits (> 0 Ohm)

 "Semi"−interruptions (< infinite)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 166 167

Komentáře k této Příručce

Žádné komentáře

Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) Uživatelský manuál Strana 94

Komentáře k této Příručce

Související produkty a manuály pro Hardware Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x)