Lenze EMF2178IB Uživatelský manuál stáhnout pdf (Strana 66)

7 Commissioning

Possible settings via DIP switch

EDKMF2178IB DE/EN/FR 6.0

H1inbet−HINW_Einst_aktivieren_KommModule

7 Commissioning

Possible settings via DIP switch

The front panel DIP switches serve to set:

ƒ The node address (switches 1 ... 7)

ƒ The baud rate (switches 8 ... 10)

The Lenze setting of all DIP switches is OFF.

) Note!

Settings via codes

ƒ In the Lenze setting ˘ Address switches 1 ... 7 = OFF ˘, the values are

accepted from the codes C1850/C2350 (node address) and C1851/C2351

(baud rate).

– Node addresses > 99 can only be set via DIP switch.

– The baud rates 10 kbps and 20 kbps can only be selected via DIP switch.

ƒ Writing the codes (e.g. with GDC via CAN) has a direct effect on the

standard device codes C0009 and C0126.

ƒ Acceptance of code changes by:

– Switching off and then on again the voltage supply,

– "Reset node" with C0358 = 1;

– Network management command "Reset Communication";

– Set C2120 (AIF control byte) = 1.

ƒ The codes are inactive if at least one address switch (1 ... 7) has been set to

ON position before a renewed mains connection.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 117 118

Žádné komentáře

Lenze EMF2178IB Uživatelský manuál Strana 66