Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Uživatelský manuál Strana 322

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 679
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 321
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Electronic gearbox" | Brake control
322 Firmware 1.37 - 09/2006 L
12.2.12 Brake control
[12-22] Basic function "Brake control" (schematic diagram)
O Tip!
Detailed information on brake control can be found in chapter "Basic drive
functions" subchapter "Brake control
". (C 211)
The basic function "Brake control" serves to the wear free
control and monitoring of a holding brake.
In the simplest case, an optionally available brake module
is used.
Alternatively the holding brake can also be controlled and
monitored via the digital inputs/outputs.
M
LS_Brake
Note!
In the Lenze setting the brake control is switched off to reach a safe status after
mains connection.
Zobrazit stránku 321
1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 678 679

Komentáře k této Příručce

Žádné komentáře