
9400 HighLine | Parameter setting & configuration
Drive interface
LED status displays
34 Firmware 1.37 - 09/2006 L
4 Drive interface
This chapter describes the drive interface which serves to set the controller to different
states and query different status information of the controller. Moreover, the machine
constants for the motor end can be entered via this drive interface.
4.1 LED status displays
The control of the "DRIVE READY" and "DRIVE ERROR" LED on the front of the controller
depends on the device status.
Device states (C 45)
O Tip!
The current device state is also displayed in C00183
.
DRIVE READY DRIVE ERROR Meaning
OFF OFF Status "initialisation active"
OFF Status "Safe torque off active"
Consider LED on the safety module!
OFF State "Device is ready to switch on"
OFF State "Device is switched on"
OFF State "Operation"
State "Warning active" or State "Warning locked active"
The controller is ready to start, switched on or the operation is
enabled and a warning is indicated.
State "Quick stop by trouble"
OFF Status"Trouble active"
OFF State "Fault active"
OFF State "System fault active"
Legend
Meaning of the symbols used to describe the LED states:
LED flashes once approx. every three seconds (slow flash)
LED flashes once approx. every 1.25 seconds ( flash)
LED flashes twice approx. every 1.25 seconds (double flash)
LED blinks every second
LED is permanently on
DRIVE READY DRIVE ERROR
Komentáře k této Příručce