Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Uživatelský manuál Strana 361

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 679
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 360
L Firmware 1.37 - 09/2006 361
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | Brake control
12.3.11 Brake control
[12-38] Basic function "Brake control" (schematic diagram)
O Tip!
Detailed information on brake control can be found in chapter "Basic drive
functions" subchapter "Brake control
". (C 211)
The basic function "Brake control" serves to the wear free
control and monitoring of a holding brake.
In the simplest case, an optionally available brake module
is used.
Alternatively the holding brake can also be controlled and
monitored via the digital inputs/outputs.
M
LS_Brake
Note!
In the Lenze setting the brake control is switched off to reach a safe status after
mains connection.
Zobrazit stránku 360
1 2 ... 356 357 358 359 360 361 362 363 364 365 366 ... 678 679

Komentáře k této Příručce

Žádné komentáře