Lenze 9400 Uživatelský manuál stáhnout pdf (Strana 131)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 131

5 Motor interface

5.3 Adjusting motor and controller to each other

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

After successful completion...

...the controller is inhibited automatically and the pole position determined for the activated

feedback system is set in the corresponding subcode of C00058

.

• For a permanent acceptance of the identified pole position, the parameter set must be saved

(C00002

= "11: Save start parameters").

• The next controller inhibit and subsequent controller enable serve to cancel the controller

inhibit automatically set by the procedure (e.g. by first executing the device command

C00002

= "41: Inhibit controller" and then executing the device command C00002 = "42: Enable

controller").

In the event of a fault

If an error occurs during the procedure or the pulse inhibit gets active (e.g. due to short-time

undervoltage), the procedure is terminated with controller inhibit without making a change in

C00058

.

If the machine was braked or blocked during the procedure, this will be recognised at the end of the

measurement and no change is made in C00058

.

From software version V4.0 onwards, the response parameterised in C00640

(Lenze setting: "Fault")

is triggered and the error message "Pole position identification cancelled" is entered in the logbook

of the controller if the pole position identification process is aborted.

 Tip!

From software version V7.0 onwards, the pole position identification is additionally

available as a basic function in the form of the LS_PolePositionIdentification

system block.

Basic drive functions:Pole position identification

( 570)

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 953 954

Komentáře k této Příručce

Žádné komentáře