Lenze 9400 Uživatelský manuál stáhnout pdf (Strana 699)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 699

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Motor brake: Status monitoring error [0x00b80005]

Positive software limit switch overtravelled [0x00b80007]

Negative software limit switch overtravelled [0x00b80008]

Positive direction of rotation limited [0x00b80009]

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 5

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Faulty external feedback of the brake status to the brake

control.

• Check brake configuration with regard to the control

selection in C02580

.

• Check setting for status input monitoring in C02583

.

When monitoring is active, the input bBrakeApplied

must be triggered correctly (bBrakeApplied =

bBrakeReleased).

• Check voltage supply of the brake module.

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 7

Response (Lenze setting printed in bold) Setting: C02716/2 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The positive software limit position parameterised in

C02702/2

has been overtravelled.

• Position within the software limit positions.

• Increase permissible traversing range (change setting

of the software limit positions).

• Deactivate monitoring of the software limit positions

by the basic function "Limiter".

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 8

Response (Lenze setting printed in bold) Setting: C02716/2 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The negative software limit position parameterised in

C02702/1

has been overtravelled.

• Position within the software limit positions.

• Increase permissible traversing range (change setting

of the software limit positions).

• Deactivate monitoring of the software limit positions

by the basic function "Limiter".

Module ID (decimal) Error ID (decimal)

184: Basic drive functions 9

Response (Lenze setting printed in bold) Setting: C02716/1 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Due to the setting of C02707 it was tried to traverse in

the impermissible positive direction of rotation.

• Only traverse in permissible (negative) direction of

rotation.

• Change setting of the permissible direction of

rotation (C02707

).

1 2 ... 694 695 696 697 698 699 700 701 702 703 704 ... 953 954

Komentáře k této Příručce

Žádné komentáře