Lenze 9400 Uživatelský manuál stáhnout pdf (Strana 629)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 629

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

MXI2: Module has been changed [0x00680016]

Memory module has been changed [0x00680017]

Safety module has been changed [0x00680018]

Combination MXI1/MXI2 not possible [0x00680019]

Firmware has been changed [0x0068001a]

Module ID (decimal) Error ID (decimal)

104: Module identification 22

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The extension module in module slot MXI2 has been

changed since the last mains switching.

(Only information or warning locked if the hardware

type has also changed.)

Module ID (decimal) Error ID (decimal)

104: Module identification 23

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The memory module has been changed since the last

mains switching.

(Only information or warning locked if the hardware

type has also changed.)

Module ID (decimal) Error ID (decimal)

104: Module identification 24

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The safety module has been changed since the last

mains switching.

(Only information or warning locked if the hardware

type has also changed.)

Module ID (decimal) Error ID (decimal)

104: Module identification 25

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Extension modules which are not supported in this

combination are plugged into module slots MXI1 &

MXI2.

Create permitted module combination.

Module ID (decimal) Error ID (decimal)

104: Module identification 26

Response (Lenze setting printed in bold)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

The firmware of the operating system has been updated. - (Information only)

1 2 ... 624 625 626 627 628 629 630 631 632 633 634 ... 953 954

Komentáře k této Příručce

Žádné komentáře